China successfully tests ITER Prototype HTS Current Lead

qinsdau

中科院合肥等离子所成功研制并试验成功‘全超导非圆截面托卡马克核聚变实验装置’
A prototype of the 68 kA High Temperature Superconductor (HTS高温超导) current lead for the ITER Toroidal Field (TF) coil has been successfully tested in the Institute of Plasma Physics of the Chinese Academy of Sciences (ASIPP) in Hefei, China. On 17 and 18 December, the HTS current lead has been operated at 85 kA for several minutes and 90 kA for 5 minutes. The 90 kA level is more than 32 percent above the nominal operating current.

                               
登录/注册后可看大图

Test-cryostat, i.e. cryogenic vacuum vessel containing the HTS current leads.

The high temperature superconductor current leads are designed to transmit high power currents from the room temperature power supplies to the low temperature superconducting coils with minimum heat load. For this they use a short segment of a High Temperature Superconductor which can carry much higher current-densities than a normal conductor such as copper. It can thereby conduct the current in much less material (smaller cross-section), thus reducing the heat conduction. The heat load reduction by the HTS current lead results in a decrease of the power input, and thus will greatly improve the efficiency of the ITER device and dramatically reduce the operation cost. The HTS current lead technology is therefore one of the "enabling" technologies for a fusion Tokamak.

                               
登录/注册后可看大图

Ananta Sahu (IO), Yuntao Song (ASIPP), Yanfang Bi (ASIPP), Pierre Bauer (IO)

The Institute of Plasma Physics of the Chinese Academy of Sciences (ASIPP) in Hefei, China, started the development of such current leads more than one year ago. The HTS current leads are part of the so-called feeders, a set of ITER components provided entirely by China.

                               
登录/注册后可看大图

Ananta Sahu, Pierre Bauer, Yanfang Bi, Yuntao Song, ASIPP director Jiangang Li and the ASIPP team responsible for the design, manufacturing and testing of the first ITER prototype HTS lead.

In another test the 68 kA HTS current lead was operated in steady state for 42 minutes. The test confirmed the simulated low temperature end conduction heat-load of less than 10 W per lead. It also revealed a current lead to the busbar joint resistance of less than 1nOhm, which is lower than expected. The busbar is a superconducting cable operating at low temperature, which transmits the current further to the TF coils. All of these results are preliminary and more test results will be delivered in the near future. 90 kA operation establishes a new world record for the operating current of a HTS current lead. With this successful test ASIPP, China and the world just made a big step toward ITER.
-Pierre Bauer
qinsdau转自iter官方新闻网